Commercial roof due diligence and PCA roof reports

On a net lease asset the roof is most of the capital risk

Where the rent is fixed and the tenant carries the running costs, the roof is one of the few things left that can cost an owner real money. Diligence on a retail asset is therefore two exercises at once: reading the roof, and reading the lease that decides who pays for it.

On a retail or net lease asset the roof is small in area and large in consequence. The covering may be a fraction of the size of an industrial roof, yet it sits above trading tenants, carries most of the building services, and is frequently the only significant capital item an owner is exposed to once the lease has passed the running costs across.

That makes the diligence question different. It is not only what condition the roof is in. It is who pays for each category of work under each lease, what can be recovered and from whom, and whether the roof will reach the next lease event without spending.

Two documents, read together

The roof report tells you The lease tells you
System, age and condition by area Whether repair and replacement are split
Remaining life and its range What can be recovered, and any cap
The repairs needed now Who is obliged to carry them out
Detail and equipment problems Who may install on the roof, and on what terms
What a replacement would involve Whether the term is long enough to matter

Neither document answers the question alone. A roof in poor condition on a long lease where the tenant carries full repair is a different risk from the same roof on a lease expiring next year, and the roof section of a condition assessment will not say which you have.

What to walk, and in what order

Retail roofs are detail dense rather than area heavy, so scope the inspection by count. Start at the front: the parapet, the coping, the counterflashing behind it and every fixing driven through for signage. Then the equipment: curbs, flashings, condensate discharge, and any unit set straight onto the membrane. Then the drainage, including where the overflow is meant to go when the primary drain blocks.

Food tenancies deserve their own note. Grease discharge attacks some membranes and not others, so the covering above a kitchen may be at a different point in its life from the sheet twenty paces away. Record it as a separate area with its own condition.

Where the money question actually sits

  1. Read every lease for the repair, replacement, structure and alterations clauses.
  2. Map the roof areas onto the tenancies, since leaks are reported by unit and repaired by area.
  3. Establish what is recoverable, and at what occupancy that recovery is real.
  4. Set the remaining life of each area against the lease expiry dates.
  5. Decide which areas are owner spend inside your hold period, and price those.
  6. Treat the rest as a disclosed risk rather than a cost.

Step three is where models go wrong. Recovery is a function of what the leases permit and of how full the center is, and a vacant unit recovers nothing. Whether roof spending is capital or operating also changes the recovery route on many leases, so the classification is worth settling during diligence rather than after the first invoice.

Using the finding in the deal

A retail roof finding is usually too small to reprice a deal and too certain to ignore, which makes it natural holdback territory. How a roof holdback is structured matters more than its size here, because the work is often sectional and will be carried out in phases while tenants trade.

Where the seller offers to carry out the repair instead, be specific about what completion means. Sectional work on a trading center is disruptive, and a repair signed off because the invoice arrived is not the same as one signed off because somebody walked the roof afterwards. The document request list is also the place to ask for the warranty conditions, since most membrane warranties exclude damage from unauthorised tenant work and a center is where that exclusion is most likely to bite.

Where to go next

Read how a remaining life figure is put together and then set it against your lease expiry schedule, because on this asset class the two dates decide the answer between them. Then get the roof mapped onto the tenancy plan, which is the record every later decision depends on.

Common questions

Who pays for the roof under a net lease?

It depends on the wording, and the answer is less uniform than the label suggests. Many net leases make the tenant responsible for repair and leave the structure and the roof with the landlord. Others pass the whole roof across, sometimes with a carve out for replacement.

  • The label matters less than the clause
  • Repair and replacement are often split
  • Structure is frequently landlord retained
  • Caps and exclusions change the exposure
  • Read every lease, not the rent roll

Read the maintenance, repair and alterations clauses in each lease rather than relying on how the asset was marketed. Where the tenant repairs and the landlord replaces, the practical effect is that the owner inherits whatever standard of repair the tenant has been applying, which makes the repair history as important as the lease wording. Your own advisers should interpret the clauses, and the roof report should be read beside them, because a condition finding only becomes a number once you know who carries it.

Can a roof replacement be recovered through common area charges?

Sometimes in part, and rarely in full. Recovery usually turns on whether the lease treats the work as a repair, an operating expense or a capital improvement, and on any cap or amortisation provision. The answer differs lease by lease inside the same center.

  • Repair and capital are treated differently
  • Amortisation provisions spread the cost
  • Caps limit what can be passed through
  • Vacant units recover nothing at all
  • Older leases are often silent

Two practical points follow for diligence. Occupancy decides the real recovery rate, so a center with vacant units carries the shortfall itself whatever the leases allow. And the way the work is specified can change its character: a repair programme and a replacement of the same area may be recoverable on different terms. Model the recovery you can actually support from the leases you have read rather than from an assumed percentage, and treat the balance as owner spend.

What does a short remaining lease term do to a roof decision?

It changes the question from what the roof needs to what the asset needs. A covering with several years left under a lease expiring sooner is a leasing problem rather than a roofing one, because the renewal or the reletting will decide what gets spent and when.

  • Align roof life with lease expiry
  • A reletting often triggers roof spend
  • Incoming tenants inspect the roof
  • Short term repairs can bridge a gap
  • Replacement can be a leasing incentive

Set the remaining life against the lease events rather than against the calendar. Where the two are close together, the useful diligence output is a figure for each path: hold and repair, or replace as part of a letting package. An incoming tenant with any sophistication will commission its own survey, so a roof that is visibly finished becomes a negotiating point at exactly the moment the owner has least room. Knowing that before closing is worth more than a marginally better unit rate.

Which parts of a retail roof should be walked first?

The front elevation and the equipment. Parapets, coping, signage fixings and the canopy junction concentrate more details into a small area than anywhere else on the building, and rooftop units sit on curbs that were often altered when a tenancy changed.

  • Parapet, coping and counterflashing
  • Signage and canopy penetrations
  • Equipment curbs and condensate lines
  • Drains, scuppers and overflow paths
  • Grease discharge above food units

The field membrane is usually the last suspect rather than the first on this asset class, which is the opposite of the order on an industrial roof. Retail roofs are small in area and dense in detail, so the inspection should be scoped by detail count rather than by area. Ask for the penetration count, the curb count and the drainage arrangement to appear in the report, because those are the numbers a contractor needs later in order to price anything, and they are tedious to collect on a second visit.

What roof documents does a net lease seller usually hold?

Less than a buyer expects. Where the tenant has carried the repair obligation, the invoices, the roofer's reports and the alteration records sit with the occupier rather than with the owner, and the seller may genuinely have nothing beyond the original warranty.

  • Repair records often sit with the tenant
  • Alterations consents may be incomplete
  • Warranty conditions are rarely monitored
  • Estoppels can be used to ask the tenant
  • A thin file is itself a finding

Use the tenant enquiry process to ask the questions the seller cannot answer: who has worked on the roof, when it last leaked, and whether anything has been installed on it. A thin document file does not prove neglect, but it does mean the roof has to be judged on what is visible rather than on its history, which widens the range on any remaining life figure. Record that limitation in your own numbers rather than reading the silence as good news.

Book a diligence inspection

Three things and we will call you back. No obligation.

Or call (646) 643-3790